Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Before
After
Before
After
Before
AfterGarage Door Before & After in Marietta, GA
Photos tell the truth faster than any claim we could make. What follows are real jobs from Marietta streets: snapped torsion springs on Holly Springs Road, opener logic boards that died mid-cycle in East Cobb, dented panels from a Tuesday morning on Whitlock. Every project close-out includes the same documented photo record we hand the homeowner, so what you see here is what leaving looks like when the truck pulls away.
Recent Transformations
Torsion Spring Replacement on a 16×7 Clopay in West Marietta
The homeowner called at 6:40 a.m. because the door wouldn’t lift more than six inches. We found the left torsion spring had snapped at the coil, the right spring was within 400 cycles of the same failure, and the cable had jumped the drum. We replaced both springs as a matched pair, reset the cables, and rebalanced the door so it holds at half-mast without drift. The photo record showed the new spring wire diameter, the winding cone count, and the balance test result. Total time on site: 84 minutes.
Garage Door Opener Logic Board Failure in East Cobb
This LiftMaster 8500W would click once and do nothing. We measured power at the board input, confirmed the capacitor was fine, and isolated the failure to the logic board itself, which had a visible scorch mark at the relay. Replacement took about an hour, and because the unit was under seven years old, we used a factory board rather than a generic. The written scope listed the part number before we touched a screwdriver.
Bottom Panel Replacement After a Reversing Incident in Kennesaw Mountain Area
A rear bumper met the bottom panel while the door was halfway down. The panel was creased badly enough that the door bound in the tracks on the way up. We ordered the replacement panel through Amarr’s Atlanta distribution, matched the existing paint code, and reinstalled with new weatherseal and hinge reinforcement. The customer received a photo of the dented panel, the new panel staged beside it, and the finished door from both inside and outside. Job done in one visit after the panel arrived.
Full System Swap: 18-Year-Old Wayne Dalton to a New Clopay with Genie Opener in Powder Springs
This door had been patched, braced, and coaxed along for longer than most cars stay on the road. The panels had separated at the edges, the track rollers were grinding, and the old opener sounded like a freight elevator. We quoted a full replacement with a written line-item scope: Clopay Gallery steel door, Genie 7155-TKV opener with battery backup, new two-inch track, new weatherseal, and haul-away of the old assembly. The install took one day, and the before and after photo set included the old spring system tagged for disposal. The difference in sound is the first thing the homeowner noticed.
Emergency Cable Repair After a Door Jumped the Track on Burnt Hickory Road
Saturday afternoon, a homeowner backed out with the door still rising and caught the bottom edge. The door jumped the left track, the cable whipped off the drum, and the door wedged itself in the opening. This is one of those calls where the door is heavy and the energy stored in the springs is not something to guess at. We reseated the cable, retensioned the drum, leveled the door, and ran a fresh safety cable through the spring as a precaution. The flat price was quoted on the phone before we left the shop, and the written scope matched the phone quote to the dollar.
Roller and Hinge Replacement to Quiet a 12-Year-Old Genie Door in Sandy Plains
The homeowner said the door sounded like a filing cabinet falling down stairs. We pulled the rollers and found flat spots on four of them, plus hinge sleeves that had ovalled out from years of dry cycling. Replaced all rollers with nylon-bearing units and all hinges with new OEM parts. While we were in there, the photo record showed the bolts backing out of the vertical track at the floor, which we retorqued as part of the same scope. The door now runs about as loud as a refrigerator opening.
Want Results Like These?
Every one of these jobs left the driveway with a written price agreed before the work, a documented photo record, and the same 365-day promise. No exceptions, no fine print, no “we’ll see when we get there.” If your garage door needs a repair, a replacement, or a second opinion on someone else’s estimate, call (470) 486-7771. A real person answers, and the price you’re quoted is the price you see in writing before any work begins.
Written by Marcus Deller, Owner at Servo Garage Doors Marietta, serving Marietta since 2015.