Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Raynor Weather Seal Replacement: The Marietta Owner’s Guide
A Raynor weather seal replacement in Marietta typically runs $110-$220 installed, and we stock the common profiles on our trucks so most jobs are done the same day we arrive. The weather seal is the vinyl or rubber strip along the bottom of the door that keeps rain, leaves, bugs, and Georgia humidity out of your garage. You’ll usually spot the failure the morning after a hard Cobb County downpour, when the floor near the door is wet and the old seal looks cracked, flattened, or chewed up at the ends.
We photograph the failed seal before we quote anything. That’s Clause 4 of The Haven Standard, and it’s been the way Marcus Deller has run jobs since 2015. You see what we see, then we hand you a flat written price before a single screw comes out.
Which Raynor Models This Applies To
Raynor uses a few different bottom seal profiles depending on the door series and vintage. Most residential Raynor doors built in the last 15 years, including the Aspen, Mesa, and Pinnacle series, take a T-style or bulb-style vinyl seal that slides into a retainer channel at the bottom of the door. Some older models use a simple U-shaped astragal that wraps the bottom panel edge directly.
The gotcha with Raynor is that the retainer channel width isn’t universal. We’ve pulled seals off doors where the previous seal was a generic 1/4-inch T profile wedged into a channel that actually needed a 5/16-inch bead. It holds for about a season, then the wind peels it right out. That’s why we measure the channel and match the profile, not the brand sticker. OEM Raynor seals are fine, but brands like Universal and Action Industries make equivalent profiles that hold up just as well and often cost less per foot. We stock both and tell you the difference before you decide.
Servo Garage Doors Marietta is an independent service provider, not a Raynor dealer or affiliate. We simply work on these doors more than most shops in the Marietta area, and we keep the parts that fail in this climate on hand.
For reference, our trucks also carry parts for LiftMaster, Chamberlain, and Genie openers, so if the issue ever runs past the seal into the opener, we’re already equipped.
Signs Your Raynor Weather Seal Replacement Is Failing

- Daylight under the door. When the door is closed, any gap at the bottom means the seal has lost its shape or the door’s travel limits are off. The seal is almost always the culprit here.
- Water pooling inside the garage after rain. Marietta gets 52 inches of rain in an average year, and a flattened seal turns every gullywasher into a slow drip across the garage floor.
- Leaves, dust, or grass clippings blowing in. The seal isn’t just for water. Once the bulb shape collapses, the bottom of the door effectively stops sealing against anything.
- Visible cracks, splits, or a “frozen” brittle section. Georgia summer heat bakes the vinyl, and after three to five years the material starts to lose its flexibility. The ends are always the first to go.
- Rodent or insect traffic. A worn seal leaves a gap that ants, palmetto bugs, and mice find within days. We see this constantly in older neighborhoods near Marietta Square where crawl spaces meet garage walls.
Before
AfterReplacement Cost & What’s Included
In Marietta, we install Raynor-compatible weather seal for $110-$220, and that range is the flat price you’ll see on the written quote before work starts. What moves the number is the seal profile, the length of the door, and whether the retainer channel itself is bent or needs replacement along with the vinyl. A standard 16-foot single door with a clean channel is a quick job at the lower end. An 18-foot door with a mangled aluminum retainer runs higher.
That price includes the seal, removal of the old material, cleaning and straightening the channel, installing the new seal, and a photo record of what we removed and what we installed. If the work isn’t right, the 365-Day Done Right Promise covers it. No call-for-a-quote games, no surprise labor line items. Clause 1 of The Haven Standard is a written price before any work begins, and it applies to every weather seal we’ve ever done.
DIY or Call Us?

Weather seal replacement is one of the safer garage door jobs an owner can do themselves. The parts aren’t under tension, and replacing a bottom seal doesn’t require moving the door off its tracks. The problem is usually getting the right profile. Buy a generic seal at a big box store, force it into a Raynor channel it doesn’t quite fit, and it’ll fall out within months. If you want to check your own door, look at the retainer channel width and measure the old seal’s T-bead or bulb diameter. But if the old seal is so far gone you can’t tell what shape it was, that’s when the job gets difficult.
If you’d rather someone just make it right, call us at (470) 486-7771. We’ll quote the repair flat before we start, and you’ll have a photo record of the old seal and the new one when we leave.
FAQs
A Raynor weather seal in Marietta typically lasts three to five years before the Georgia sun and humidity break down the vinyl enough that it stops sealing. Doors that face south and get full afternoon sun tend to fail on the shorter end of that range. Call (470) 486-7771 for a flat quote on a replacement.
Weather seals can’t be reliably repaired, because once the vinyl cracks or collapses, gluing or patching it won’t restore the flex the seal depends on. The only durable fix is a new piece of seal cut to length. We show you the failed section before we quote, so you know exactly what you’re paying for.
Most weather seal replacements take 30 to 45 minutes once we’re on site, assuming the retainer channel is in good shape. We carry the common profiles on the truck, so there’s usually no second trip for parts. If you need an exact quote first, call (470) 486-7771.
Yes, we stock the T-style and bulb-style profiles that fit most residential Raynor doors, plus the retainer channels for the common widths. If your door has an unusual channel size, we’ll measure it on the first visit and return with the correct profile, quoted in writing before any work begins.
Written by Marcus Deller, Owner, Servo Garage Doors Marietta at Servo Garage Doors Marietta, serving Marietta and nearby areas.






Before
After
Before
After